Cabinet Builder
Pick a unit, type your sizes and watch it draw. We work out every part — cut, edged and labelled, ready to build. Add each unit to your job, then send the lot in one go.
1 Pick a unit2 Sizes & fronts3 Add to job4 Send to us
Editing from your job
1Unit type & size
2Inside
Heights are to the top of the shelf, measured from the bottom of the unit. Internal drawers sit at the bottom (in the shelf side on half layouts — not offered on full double hanging), on packers so they clear the door hinges. LEDs run down the gables — they need a service void behind the back so the cables can reach the driver. Drawer boxes, runners and LEDs aren't cut by us; they're listed so nothing gets missed.
3Doors & drawers
4Board & finishing
Construction settings
Defaults: 18mm carcass & backs, back set in with a 40mm void (20mm on wall units & wardrobes), shelves 20mm back from the front, 3mm door gaps, 150mm legs on base & tall units.
Your unit
| Part | Qty | Size (L × W) | Edge |
|---|
Your job
No units yet
Build a unit above and press Add to job. Add as many as you need — a whole kitchen or wardrobe run — then send them all as one cutlist.
Always check your sizes. This parts list is a guide based on standard construction: carcass & backs 18mm, sides full height, top/bottom between the sides, base & tall units on legs with a kicker (kicker is totalled for the run and cut to fit on site). Decor end panels include scribe allowance (20mm to wall & floor) and fillers are "finish TBC" — tell us the finish when you order. Drawer boxes are not included in the cutlist. Nothing is ordered until we've checked it and confirmed with you.